Télécharger Imprimer la page

MTD Yard-Man 11AS439T501 Manuel Du Propriétaire page 7

Publicité

Les langues disponibles

Les langues disponibles

This unit is shipped WITHOUT GASOLINE
or OIL. After assembly, service engine with
gasoline and oil as instructed in the separate
engine manual packed with your unit.
NOTE: Reference to right or left
hand side of the mower is observed
from the operating position.
HOW TO SET-UP YOUR LAWN MOWER
Refer to Illustration Below
1. Disconnect the spark plug wire and move
it away from spark plug.
2. Remove the carton inserts (if any). Remove
the loose parts which are in the carton, lift
the mower from the carton, or cut the cor-
ners of the carton and roll the mower out.
3. Pull up and back on the upper handle to
raise the handle into the operating posi-
tion. Make certain the lower handle is
seated securely into the handle mounting
brackets. Tighten the hand knobs on each
side of the handle.
4. Remove the cotter pin from the outer hole
in the weld pins on the handle mounting
brackets. Place the cotter pin in the inner
hole.
5. The rope guide and wing nut are attached
to the starter rope, on top of the engine.
Rope
Guide
Starter
Rope
Mulching Plug
Side
Discharge
Deflector
Figure 1
SET-UP INSTRUCTIONS
Wing Nut
Upper
Handle
Handle
Knobs
Recoil
Starter
Remove the wing nut from rope guide.
Remove the rope guide from the starter
rope.
6. With the spark plug wire disconnected and
grounded (as instructed in the separate
engine manual), and with the safety key in
the locked position, pull the starter rope
out of the engine. Hold the rope guide as
shown so the opening in the rope guide is
toward the front of mower. Slip the rope
guide around the starter rope and into the
right side of lower handle using the hole
shown. Secure using the wing nut.
7. Make certain all nuts and bolts are tight-
ened securely.
Your mower has been shipped as a
mulcher. To discharge grass to the side,
proceed to page 8.
ATTACHING GRASS CATCHER TO
MOWER
1. Lift the rear discharge door on the mower,
and remove the rear mulching plug. See
Figure 2.
NOTE: Make certain cables are routed
to the outside of the handle so they are
not in the way when attaching the grass
catcher.
Blade Control Handle
Lower Handle
Handle Mounting
Start
Control
Button
Side
Mulching
Discharge
Plug
Deflector
7
Cotter
Pin
Bracket
Spark Plug
Weld
Pin
Safety
Key

Publicité

loading

Ce manuel est également adapté pour:

Yard-man 11a-434n501