BWT OMEGA Notice De Montage page 13

c) Line up the axle profiles and slide the lateral elements into each side of the central element, push them
in the same distance such that the axle length is approximately equal to the cover width + 30 cm. If the
axle is too long when the lateral elements are pushed fully in, shorten each of the lateral elements by half
of the superfluous length.
11
13
3.3 Assembly of the stands
3
PROTECTION & SÉCURITÉ
12
b) Push an axle end piece 7 into this end of the lateral element and fix
it in position by inserting a screw 12 through the hole in the axle
element.
7
d) Once the length is properly adjusted, lock each lateral element into
position using screws 13. The screws (13) are inserted from the
outside through a hole at each end of the central element (11) and
engage in free hole of the gib (which should be slid along until it
aligns with the screw (13).
e) Clip on a bungee strap for every eyelet across the width of the
cover to be attached to the axle :
The central straps clip into groove in the central element, the lateral
bungee straps clip into the grooves in the lateral elements that
holds the gibs. Adjust the position of the bungee straps so that they
align with the eyelets in the cover.
The stand that has a metal rod at each of its ends should be fitted
with wheels; the flywheel should be mounted on the stand with the
black caps.
Push each of the wheels onto a rod, put the locking clips (3) on the
end of the rod to prevent the wheel from falling off.
2019/05 - Indice de révision : C - Code : 32001
13/16