Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Fax +1 305 430 9692
#
Outside cleaning
·
Wipe clean with soft dry cloth or paper toweling
·
Do not use steel wool, scouring pads or abrasive cleaners.
Do not immerse in water or any other liquid.
HOW TO USE THE COFFEE MAKER
·
Open the lid of the water tank and pour the desired volume of
water in it. The water level can be read off the water level
indicator on the water tank. Never exceed the maximum level
indicated.
·
Swing the filter holder by pulling at its handle, insert a paper filter
or permanent filter (depending on the model) in the filter holder
and add the desired quantity of ground coffee.
·
Put the filter holder back into its initial position and make sure it is
closed properly.
·
Never forget to close the lid of the water tank before switching
on your coffee maker.
·
Put the glass jug with closed lid on the base of the appliance.
·
Switch on the coffee maker. The pilot light of the switch will be
illuminated, indicating that your appliance is operating. Thanks to
the keep warm function, your coffee is warmed up as long as the
appliance is switched on. Note that the appliance will be
switched on as long as you do not switch it off manually.
However, we advise you not to let the appliance switched on
more than 2 hours and make sure that you never let an empty jug
on the appliance.
·
When you remove the jug from the appliance, a non-drip valve
will automatically operate to stop any drops of coffee dripping
onto the hotplate. Replacement of the carafe automatically
opens the non-drip valve and allows remaining coffee to filter
trough into the jug.
·
When the water tank is empty, wait a few additional minutes
before removing the jug.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
7
Assembly page 7/28
USK BSET 15191 - 111026
Publicité
