Publicité
SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft (A).
To install the pump handle place the handle (C) over the shaft (A)
aligning the pump handle hole and shaft hole. Push the straight side of
the cotter pin (B) through the aligned hole as shown in figure 1 thru 3.
There are holes in the pump handle to allow for either left(fig.4) or right
(fig.5) hand mounting.
Figure 1
Cotter Pin
Figure 4
Left Hand
STOWAWAY PUMP HANDLE
Pull
up
INSTALLING THE SHOULDER STRAP
The backpack strap is provided with multiple features including shoulder strap, chest
strap, waist belt, lumbar support and back pad (figure 1). The top of both the shoulder
strap and back pad strap are attached to the top of the tank and are removable. The
back pad strap attaches to the bottom of the tank (figure 2). The back pad is attached
to its strap with velcro and is removable ( figure3). The strap from the lumbar support
attaches to the base tube on the bottom of the tank (figure 4).
NOTE: If your straps become contaminated with dirt or chemicals, wash with mild
soap and water and let dry overnight. If this does not remove the contamination,
replace with new straps.
Figure 2
Back Pad strap attachment
All manuals and user guides at all-guides.com
Figure 2
Line up holes
Figure 5
Right Hand
Rotate
180º
Back Pad
Removable
Strap
Back Pad
Velcro
Attachment
Figure 3
Removable Back Pad
3E
C
Figure 3
Slide pin through holes.
Pump Handle
Positioned For Use
(right hand shown)
Set
into
slot
Figure 1
Strap Assembly
Figure 4
Strap Attachment
A
B
Shoulder
Strap
Back
Pad
Chest Strap
Lumbar
Support
Waist Belt
Lumbar
Support
Base Tube
AS
Publicité
