Porter Cable PCE201 Manuel D'instructions page 5

COMPONENTS
Figure A
1. Trigger switch
2. Forward/Reverse button
3. Chuck collar
4. 1/4 inch hex quick-release chuck
5. Magnetic Bit holder
6. Belt hook
OPERATION
WARNING:
making any adjustments or changing accessories.
VARIABLE SPEED TRIGGER SWITCh (FIGURE B)
To turn the tool on, squeeze the trigger switch (1). To
turn the tool off, release the trigger switch. Your tool is
equipped with a brake. The chuck will stop as soon as
the trigger switch is fully released. The variable speed
switch enables you to select the best speed for a particular
application. The more you squeeze the trigger, the faster
the tool will operate. Use lower speeds for starting holes
without a center punch, drilling in metals or plastics, or
driving screws. For maximum tool life, use variable speed
only for starting holes or fasteners.
NOTE: Continuous use in variable speed range is not
recommended. It may damage the switch and should be
avoided.
FORWARD/REVERSE CONTROL BUTTON (FIGURE C)
A forward/reverse control button (2) determines the
direction of the tool and also serves as a lock off button.
To select forward rotation, release the trigger switch and
depress the forward/reverse control button on the right
side of the tool. To select reverse, depress the forward/
reverse control button on the left side of the tool. The
center position of the control button locks the tool in the
OFF position. When changing the position of the control
button, be sure the trigger is released.
NOTE: The first time the tool is run after changing the
direction of rotation, you may hear a click on start up. This
and the impacting noise that the tool makes is normal and
does not indicate a problem.
To reduce the risk of injury, always unplug tool from power supply before
A
4
3
1
B
C
5
2
6
1
2