Usb Storage Device; Supported Audio Formats - Onkyo TX-8260 Mode D'emploi

> Before Start > Part Names

USB Storage Device

1
Basic Operations
You can play music files stored on a USB
storage device.
Perform the following procedure when the
unit is on.
1. Plug your USB storage device with the
music files into the USB port either on
the front panel or rear panel of this unit.
2. Press NET (a) on the remote controller.
3. Press the Up/Down cursors (b) on the
remote controller, select "USB Front" or
"USB Rear" on the display, and then
press ENTER (b).
0 If the "USB" indicator flashes on the
display, check whether the USB
storage device is plugged in properly.
0 Do not unplug the USB storage
device while "Connecting..." is on the
display. This may cause data
corruption or malfunction.
4. Press ENTER on the remote controller
after reading is complete.
5. Press the Up/Down cursors on the
20
> Install > Initial Setup
2 3
remote controller to select the folder and
music file, and then press ENTER to
start playback.
0 To return to the previous display, press
RETURN (c).
0 The USB port of this unit conforms with
the USB 2.0 standard. The transfer
speed may be insufficient for some
content you play, which may cause
some interruption in sound.
> Playback
Supplementary information | Advanced Setup | Others
4
b

Supported Audio Formats

This unit supports the following music file
formats. Note that sound files that are
protected by copyright cannot be played on
a
this unit.
MP3 (.mp3/.MP3):
0 Supported formats: MPEG-1/MPEG-2
Audio Layer 3
0 Supported sampling rates: 44.1 kHz, 48
kHz
0 Supported bitrates: Between 8 kbps and
320 kbps and VBR
c
WMA (.wma/.WMA):
0 Supported sampling rates: 44.1 kHz and
48 kHz
0 Supported bitrates: Between 5 kbps and
320 kbps and VBR
0 WMA Pro/Voice/WMA Lossless formats
are not supported
WAV (.wav/.WAV):
WAV files include uncompressed PCM