Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL
DVD
Aiwa
Apex
Denon
Ferguson
Funai
Hitachi
JVC
Kenwood
Konka
Mitsubishi
Nordmende
Onkyo
Orion
Oritron
Panasonic
Philips
Pioneer
ANTENNA/CATV CONNECTIONS
Combination VHF/UHF Antenna
Single 75 ohm Cable
300 ohm Twin-lead Wire
Remove the Splitter
Splitter
UHF Antenna
300 ohm Twin-lead Wire
VHF Antenna
Single 75 ohm Cable
300 ohm Twin-lead Wire
Incoming CATV
Converter/ Descrambler
Converter/ Descrambler
Splitter
A / B Switch
Combination VHF/UHF Antenna (Single 75 ohm Cable or
300 ohm Twin-lead Wire)
Connect the 75 ohm cable from a combination VHF/UHF antenna to
the Antenna Jack. If your combination antenna has a 300 ohm Twin-
lead Wire, use the 300-75 ohm Matching Transformer (not supplied).
Combination VHF/UHF Antenna (Separate VHF and UHF
300 ohm Twin-leads)
Connect the UHF Twin-lead Wire to a Combiner (not supplied).
Connect the VHF Twin-lead to the 300-75 ohm Matching
Transformer (not supplied). Attach the Transformer to the Combiner.
Attach the Combiner to the Antenna Jack.
8
3N11301A-E
23
20
00, 17
01
18, 32
11
09
15, 29
19
05
01
21
33
24
00
03, 16
02
300-75 ohm
Matching Transformer
(not supplied)
Combiner
(not supplied)
300-75 ohm
Matching Transformer
(not supplied)
A
B
8
Raite
13
RCA
01, 06
Saba
01
Sampo
14
Samsung
10
Sharp
08
Silvania
18, 32
SMC
25
Sony
04, 26, 27, 28
Technics
00
Thomson
01
Toshiba
03
Vialta
31
Wave
22
Yamaha
00, 30
Zenith
07, 12
IN
OUT
Y
VIDEO
VIDEO
ANT (75Ω)
L/MONO
B
P
L/MONO
S-VIDEO
AUDIO
AUDIO
R
P
R
R
VIDEO 1
VIDEO 2
Separate VHF/UHF Antennas
Connect the 75 ohm Cable from the VHF antenna and the UHF
antenna Twin-lead to a combiner (not supplied). Attach the Combiner
to the Antenna Jack.
NOTE: If your VHF antenna has a Twin-lead Wire, use the 300-75
ohm Matching Transformer (not supplied), then connect the
Transformer to the Combiner.
For Subscribers to Basic Cable TV Service
For basic cable service not requiring a Converter/Descrambler box,
connect the CATV 75 ohm Coaxial Cable directly to the Antenna
Jack on the back of the television.
For Subscribers to Scrambled Cable TV Service
If you subscribe to a cable service which requires the use of a
Converter/Descrambler box, connect the incoming cable to the
Converter/Descrambler box and connect the output of the box to the
Antenna Jack on the back of the television. Follow the connections
shown left. Tune the television to the output of the Converter/
Descrambler box (usually channel 3 or 4) and use the Converter/
Descrambler box to select channels.
For Subscribers to Unscrambled Basic Cable with
Scrambled Premium Channels
If you subscribe to a cable service in which basic cable channels are
unscrambled and premium channels require the use of a Converter/
Descrambler box, you may wish to use a two-set signal splitter
(sometimes called a "two-set coupler") and an A/B Switch box from
the cable installer or an electronics supply store. Follow the
connections shown left. With the switch in the "B" position, you can
directly tune any nonscrambled channels on your TV. With the
switch in the "A" position, tune your TV to the output of the Converter/
Descrambler box (usually channel 3 or 4) and use the box to tune
scrambled channels.
10/9/03, 5:17 PM
(CONTINUED)
This television has an extended
tuning range and can tune most
cable channels without using a
cable company supplied
converter box. Some cable
companies offer "premium pay
channels" in which the signal is
scrambled. Descrambling these
signals for normal viewing
requires the use of a descrambler
device which is generally
provided by the cable company.
Publicité
