Publicité
Trouble
• Remote Does
☛ Battery low.
not work.
☛ Distance too far.
☛ Control Panel Display dirty.
• Heater is
☛ When the heater is in Thermostat
Blowing Cold
Mode and reaches the set
Air.
temperature it will automatically
perform a 60 second cool down
(blowing cold air) to ensure
thermostat accuracy. The Power
Light will flash during the cool
down period.
☛ Unit is in the Fan Only setting.
☛ Power Button (
pressed to turn off the heater.
• Fan Speed
☛ High Heat and Low Heat/
Doesn't
Heat & $ave
Change.
heat output of the heater and not
the fan speed. Fan runs at the
same speed on all settings.
• Unexpected
☛ You may hear a popping or
Noise.
crackling sound as the heater heats
up. This is normal and safe
operation. Once the heater heats up,
the crackling sound will go away.
• Unexpected
☛ There may be an odor or vapor
Smell.
coming from the heater the first
time you use it or after prolonged
or seasonal storage.
All manuals and user guides at all-guides.com
T R O U B L E S H O O T I N G
Troubleshooting for your Heater
Probable Cause
) may have been
MODE
settings control the
TM
Solution
✔ Change battery (2 AAA batteries, 1.5V).
✔ Remote works up to 20 feet (6m).
✔ Be sure to point remote at control panel on heater
and there are no obstructions.
✔ Make sure display panel is clean.
✔ Raise the temperature higher or change setting to
Low or High heat.
✔ Press the Mode Button to select High Heat or Low
Heat settings.
✔ Press the Power Button (
✔ Run heater in High Heat for maximum heat
output.
✔ If the noise persists call Bionaire at
1-800-253-2764.
✔ This is normal and is the result of dust or other
debris accumulating on the heating element.
Make sure the heater is in a well ventilated area
and continue running until the odor or vapor goes
away.
) to turn on the heater.
MODE
Publicité
