Publicité
Les langues disponibles
Les langues disponibles
5. Separate and strip approx 1/2" of insulation from each of the eight wires in the cable.
Twist the following cables together:
• OR and OR/WH
• GR and GR/WH
• BL and BL/WH
• BR and BR/WH
6. Remove the plastic back frame and rubber gasket from the camera. Position the back
frame and gasket over wire and attach to the wall using (2) #6 x 1 1/4" screws (supplied).
Level the back frame before tightening screws completely.
7. Attach each of the twisted pair of wires to the corresponding screw terminal on the back of the camera. Tighten
each screw securely.
8. Dress extra cable into the hole (or wall box if used) and position the camera, starting at
the top of the plastic back frame.
9. Fully seat the camera into the back frame and secure the camera with 4mm screw (supplied) thru the bottom of
the back frame and camera.
Important: If camera is exposed to outside elements, caulk should be added to the top and sides of the cam-
era at the wall surface. Do not caulk bottom surface.
Connecting Camera 1 at the TV/Monitor
1. Strip approx 2" of outer protective jacket from the category 5 or category 6 cable.
2. Separate and strip approx. 1/2" of insulation from each of the eight wires in the cable. Twist the following cables
together:
• OR and OR/WH
• GR and GR/WH
• BL and BL/WH
• BR and BR/WH
3. Attach each of the twisted pair of wires to the corresponding Camera 1 screw terminals on the back of the
TV/Monitor. Tighten each screw securely.
Connecting Optional Camera 2 at the TV/Monitor
If an optional second camera has been installed, use the following connection procedure.
1. Strip approx 2" of outer protective jacket from the category 5 or category 6 cable.
2. Separate and strip approx. 1/2" of insulation from each of the eight wires in the cable. Twist the following cables
together:
All manuals and user guides at all-guides.com
14
Publicité
