Ceiling Joist
When attic space is limited, staple antenna to ceiling joists.
Nail or Staple Through Center
Twin-Lead Connection
1. Run the 20 foot twin lead to the location where the TV/Monitor will be mounted.
2. Keep twin lead at least 12" away from metal and other wiring.
3. Provide 12" extra of antenna lead at the TV/Monitor location.
4. Attach the lead-in cable terminals of the antenna to the screw terminals of the FM antenna balun (supplied). Plug
the FM antenna balun into the FM-ANT connector on the back of the TV/Monitor.
FM Antenna with 5 foot lead-in
The antenna with a 5' lead is designed to be mounted inside the home. This antenna is installed after the cabinets
have been installed. Typically the antenna is mounted under the cabinet, above the cabinet if the top of the cabinets
is accessible, or inside the cabinet. Experiment with the antenna orientation and placement to optimize FM radio
reception. For best radio reception, extend the antenna and lead-in to its full length.
Under the Cabinet Mounting
Fasten the FM antenna using staples (not supplied) in an open space under the cabinet. Plug the FM antenna "F"
connector into the FM-ANT "F" connector on the back of the TV/Monitor.
Important: The staples used to mount the FM antenna must not have enough force to pierce the wire insulation or
break the antenna lead. Test the staple installation in an inconspicuous spot on the cabinet before actual mounting
of the FM antenna.
All manuals and user guides at all-guides.com
10