Publicité
Les langues disponibles
Les langues disponibles
Powering Up the System
Once all connections throughout the system have been checked, the power cable plug can be plugged into a 120
VAC duplex outlet. Refer to the homeowner's manual for operating instructions.
Camera Volume Adjustment
The VSC4S door camera is provided with a volume level adjustment set screw. The
adjustment has been pre-set at the factory to provide the optimal volume level at the
door camera. The volume level can be adjusted if your specific application requires
the level to be either increased or decreased. Insert a jeweler's screwdriver into the
small hole that is shown in the camera illustration. Rotate the small set screw to
adjust the volume level.
Important: Do not use excessive force to rotate the screw. Damage could occur to
the camera, and loss of audio may result. Use extreme caution when making the
adjustment. Do not use a screwdriver that is too big for the application.
Camera Lens Manual Adjustment
The VSC4S door camera is provided with a manual camera lens adjustment. The
adjustment can be used to fine tune the angle of the camera lens to compensate for
installations that are not directly in line to the viewing area. The adjustment is located
on the back of the camera, as shown in the camera illustration. Move the adjustment
control upward to lower the camera lens. Move the adjustment control downward to
raise the camera lens. Adjust the camera lens position to provide the best viewing
area for your installation.
All manuals and user guides at all-guides.com
18
VSC4S
Volume Adjustment
VSC4S
Lens Adjustment
Publicité
