S&P AIRSENS WIFI IAQ Mode D'emploi page 15

Location LED
Main PCB D17
board
D16
D18
WIFI From left
antenna to right
LED diffuser
The device displays a real-time concentration level. In operation mode 1, the
illumination is two-color while in modes 2, 3 and 4 this is three-color.
Relay + Connectair (reading) – [SW1-4=OFF]
Green: Value below set point.
Red: Value above set point.
Other modes
Green: ≤ 800ppm / ≤ 60%HR / 21-25ºC
Orange: 800 – 1200ppm / 60 – 80%HR / 18-21 ºC and 25-35ºC
Red: > 1200ppm / > 80%HR / <18ºC and >35ºC
Special limits are provided in the LED diffuser for cases where AIRSENS is in-
stalled in an area with permanently high concentration. This special mode is ac-
tivated by SW4=ON.
New colour limits
Green: ≤ 950ppm
Orange: 950 - 1350ppm
Red: > 1350ppm
Colour Description
Red On: Device powered
Red Flicking: Trying to establish communication with the
WIFI antenna without success
Yellow Blinking: On every 60 seconds indicates communica-
tion with established antenna
Green On: Powered antenna
Red On: Linked WIFI but no internet connection
Slow flashing: Reset to configure new WIFI activated
Fast flashing: Factory reset activated
Orange On: Device issuing its own WIFI (AIRSENS_WIFI_
XXXX) to connect with mobile device and link to WIFI
within its range
Flashing: Sending information to CONNECTAIR
Orange On: Error Reading equipment ID
Fast flashing: Main board info reading
EN
®
15