S&P AIRSENS WIFI IAQ Mode D'emploi page 13

INSTALLATION
This device must be installed in a dry environment (IP30), over a flat surface
through fixing points (see Fig.3) and will require a type X installation. Height in-
stallation recommended between 1,5 and 1,8m. At the same time, it is impor-
tant to choose an installation location free of conditions that could influence the
measurement such as direct sun light, too close occupant proximity, air flow
coming from windows or doors or ventilation systems.
The front cover is opened a tool pressing both pressure closures located at both
edges of the cover (see Fig.4). For safety reasons, cables must be retained using
the support provided (see Fig.5).
In case of an installation where cabling is outdoors, it must be installed inside a
cable ducting system with IP4X protection degree classified as "cable ducting with
access cover that can only be opened with a tool" according to UNE-EN 50.085-1:
Cable trunking systems and cabling ducting systems for electrical installations-
Part 1: General requirements.
START UP
WIFI network connection
To connect to a WIFI network within the coverage of the equipment and to direct
to the CONNECTAIR
1. Turn on the AIRSENS WIFI device. The red D17 LED from main PCB board will
light.
2. Connect your device (smartphone, tablet, computer) with the WIFI network
genera ted by the AIRSENS WIFI device. Depending on device used, will be
necessary to deactivate 4G/5G mobile network.
3. Search the available WIFI network in the menu of your device and select:
a. Network: AIRSENS_WIFI + 4 characters (Ex.: AIRSENS_WIFI_47b1)
b. Password: 0000 + 4 characters shown in the name of the network (Ex.:
000047b1)
4. Once connected (1), open your device's browser and enter the IP address
(http://10.10.10.1) and follow the instructions on the screen. Through this in-
terface, the AIRSENS WIFI device will connect to the fixed WIFI network (must
be 2,4GHz) within the coverage of the equipment. Use your WIFI network
password.
5. Access to www.connectairapp.com and register by following the instructions
on the screen (2).
6. When you have registered, you can assign the unit by entering the serial num-
ber [SERIAL NUMBER] with ten digits, which you will find on the back side of
the equipment cover, scanning the QR code or on the electronic board.
platform, follow steps below:
®
EN
13