Publicité
Les langues disponibles
Les langues disponibles
Installation Guide
3. MOUNTING
3.1 Mounting
Installation must be in compliance with local standards and regulations.
Heat Source (HS) — In the following sections, HS refers to the heat source which sup-
plies the flat stations. A variety of energy sources, such as oil, gas or solar power, could
be used as the primary supply to Danfoss substations. For the sake of simplicity, HS
can be taken to mean the primary supply.
Mounting:
Adequate space
Please allow adequate space around the flat station for mounting and maintenance
purposes.
Orientation
The station must be mounted so that components, keyholes and labels are placed
correctly. If you wish to mount the station differently please contact your supplier.
Drillings
Where substations are to be wall-mounted, drillings are provided in the back mount-
ing plate.
Labelling
Each connection on the substation is labelled.
Before installation:
Clean and rinse
Prior to installation, all substation pipes and connections should be cleaned and rinsed.
Thightening
Due to vibration during transport, all substation connections must be checked and
tightened before installation. Check that all hairpins in click connections are completely
pushed in.
Unused connections
Unused connections and shut-off valves must be sealed with a plug.
Should the plugs require removal, this must only be done by an authorized service
technician.
Installation:
Strainer
If a strainer is supplied with the station it must be fitted according to schematic diagram.
Please note that the strainer may be supplied loose.
Connections
Connection to the household installation and district heating pipes connections must
be made using threaded, flanged or welded connections.
The internal connections of the flat station are made by click-fit connections.
© Danfoss | DCS-SGDPT | 2022.01
EvoFlat 4.0 Flat Stations for apartments, single- and multi-family houses
Authorized personnel only
Assembly, start-up and maintenance work must
be performed by qualified and authorized per-
sonnel only.
Keyhole for mounting.
Please notice
Use of packaging types other than that with which
the device is delivered will void the warranty.
AN40274706699301-010101 | 5
EN
Publicité
