Publicité
Les langues disponibles
Les langues disponibles
D25961
TO FIT A CHISEL WITH GROOVE IN THE SHANK (FIG. 4C)
1. Pull the retainer bolt (I) and turn it by 180° to
the unlock position.
2. Hold the chisel in front of the tool holder with
the groove (H) facing upwards.
3. Insert the chisel shank into the tool holder (E).
4. Pull the retainer bolt (I) and turn it by 180° back
to the lock position.
5. Pull on the chisel to check if it is properly
locked. The hammering function requires
the chisel to be able to move axially several
centimetres when locked in the tool holder.
6. To remove a chisel pull the retainer bolt (I) and
turn it by 180° to the unlock position.
Adjusting the Side Handle (fig. 1)
The side handle (F) is assembled on the machine to
suit both right- and left-hand users.
WARNING: Always operate the machine
with the side handle properly mounted.
1. Loosen the clamp knob (C) and rotate the side
handle to the desired position.
2. Lock the side handle in place by tightening the
clamp knob (C).
OPERATION
Instructions for Use
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework and
wiring.
• Apply a pressure of approx. 20 - 30 kg
to the tool. Excessive force does not
speed up chiselling but decreases tool
performance and may shorten tool life.
Proper Hand Position (fig. 2)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
IMPORTANT: The tool must be held with two
hands at all times when in use.
All manuals and user guides at all-guides.com
Horizontal applications (fig. 2A):
Proper hand position requires one hand on the side
handle (F) and the other hand on the main handle
(B).
Vertical applications (fig. 2B):
Proper hand position requires both hands on the
main handle (B).
Switching On and Off (fig. 1)
Switching on: set the on/off switch (A) to position 1.
Switching off: set the on/off switch (A) to position 0.
Demolition, Chasing and Channelling
(fig. 1, 2)
1. Select the appropriate chisel, and clean its
2. Insert the chisel and check whether it is
3. Fit and adjust the side handle (F) and make
4. Hold the tool with two hands on the main
5. Switch on tool to run in continuous operation.
6. Always switch off the tool when work is finished
Various types of chisels are available as an option.
Only D
used with this product.
MAINTENANCE
Your D
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning
This machine is not user-serviceable. Take the tool
to an authorised D
If problems occur before this time contact an
authorised D
Accessory Maintenance (fig. 5, 6)
shank.
properly locked.
sure it is firmly tightened.
handle (B) or one hand on the main handle (B)
and one hand on the side handle (F). The tool
must be held with two hands at all times when
in use. Refer to Proper Hand Postion.
and before unplugging.
WALT recommended accessories should be
e
WALT power tool has been designed to
e
WALT repair agent periodically.
e
WALT repair agent.
e
WARNING: These chisels can be
reground only a limited number of
times. If in doubt, contact your dealer for
recommendations.
WARNING: Ensure that the cutting edge
does not show discolouration caused by
too much pressure. This may impair the
hardness of the accessory.
english
25
Publicité
