Interroll MSC 50 Mode D'emploi page 15

1.4 Load capacity of series MSC 50
The load capacity table refers to a temperature range of 0 to +40 °C.
Bearing: 6002 2RZ oiled.
Tube material Shaft version
Zinc-plated Spring shaft
steel, stainless
steel
Rigid shaft
Internal thread
1.5 Selecting the speed controller to be used
The number of MSC 50s used depends on several parameters:
• Pitch angle/angle of inclination of the conveying system
• Conveying/infeed speed
• Weight of the material to be conveyed
• Material and length of the material to be conveyed
• Target speed at the end of the conveyor
Indications for a basic calculation and a basic layout
• Test with incline of 2° to 25° (higher inclines permissible, varying results possible)
• Weights up to 10 kg: Max. distance from 2000 mm
• Weights up to 20 kg: Distance of 800 mm–1500 mm
• Weights up to 35 kg: Distance adapted to the container length
• In the case of high infeed speeds of more than 1 m/s into the gravity conveyor, we recommend installing three
to four speed controllers over a length of approx. 800 mm in order to achieve a maximum reduction in speed
immediately. The distance values given above can be applied.
• Infeed conveyors should not have any MSC 50s on the first 1000 mm from the loading side to prevent the
controlled loading point from becoming blocked with slow moving goods.
For safe operation, the final layout, and thus the number of MSC 50s used, must be determined by the
user on the basis of the intended specific use.
Version 1.0 (03/2023) Online
PU hose Dia. tube/
thickness [mm]
Without 51 x 2
With 50 x 1.5
Without 51 x 2
With 50 x 1.5
Without 51 x 2
With 50 x 1.5
Product information
Dia. shaft Max. static load
[mm] [N]
11 HEX 350
11 HEX 350
11 HEX 350
11 HEX 350
11 HEX, M8 350
11 HEX, M8 350
EN
15 von 18