Switching On The Centrifuge; Replacing The Rotor; Inserting The Rotor; Removing The Rotor - USA Scientific Microcentrifuge 24 Mode D'emploi

5.2

Switching on the centrifuge

 Switch the centrifuge on at the mains/power switch.
• The parameter settings of the last run are displayed.
• The lid opens.
5.3

Replacing the rotor

5.3.1

Inserting the rotor

1. Place the rotor vertically onto the motor shaft from the top.
2. Insert the supplied rotor key into the rotor nut.
3. Turn the rotor key clockwise until the rotor nut is firmly tightened.
5.3.2

Removing the rotor

1. Turn the rotor nut counterclockwise using the supplied rotor key.
2. Remove the rotor by lifting it vertically.
5.4

Closing the centrifuge lid

 Check correct attachment of rotor and rotor lid.
 Push down the centrifuge lid until the lid latch engages and the lid is automatically closed.
The centrifuge will close automatically.
The STOP/OPEN key lights up blue.
Operation
Microcentrifuge 24
17
Microcentrifuge 24 · Manual ·