Publicité
Using the clock, timer and control lockout.
Make sure the clock is set to the
correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
8
All manuals and user guides at all-guides.com
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during timed
baking.
To Set the Timer
Press the Timer pad.
Press the Hour and Min + or
– pads until the amount of
time you want shows in the display.
If you make a mistake, press
Timer and begin again.
Press the Start pad.
After pressing the Start pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the Timer pad, then press the Hour and
Min + or – pads until the time you want
appears in the display.
To Cancel the Timer
Press the Timer pad twice.
Control Lockout
Your control will allow you to lock out the touch
pads so they cannot be activated when pressed.
To lock/unlock the controls:
Press the Hour and Min – pads at the
same time for 3 seconds until the
display shows LOC ON.
To unlock the control, press the
Hour and Min – pads at the same
time for 3 seconds until the display
shows LOC OFF.
Press the Clock pad.
Press the Hour and Min + or –
pads to set the time of day.
Press the Start pad.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the Timer pad is pressed.
The 6 second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the Timer pad and then pressing
the Hour and Min + or – pads to enter the
new time you want.
When this feature is on and the touch
pads are pressed, the control will beep
and the display will show LOC ON.
I
The control lockout mode affects all touch
pads. No touch pads will work when this
feature is activated.
I
The adjustment will be retained in memory
after a power failure.
Publicité
