PRO-POINT 8344558 Mode D'emploi page 9

8344558
3. Select your chisel. Make sure it is in good working condition
and will not shatter or break while in use. Unscrew and
remove the retainer spring and insert the shank of the chisel.
Screw the retainer spring back on.
4. Test to make sure the chisel is firmly in place by running the
tool at no load for approximately 30 seconds. Failure to do
so could result in serious injury.
OPERATION
1. Ensure the regulator switch is in the neutral or OFF position.
2. Connect your tool to your air source.
3. Firmly grip the air hammer with both hands and place the
chisel against the workpiece.
4. Squeeze the trigger and slowly move along the workpiece.
Do not force the air hammer, let the tool do the work.
5. If the bit or chisel is not performing well, turn off the tool and
examine it to see if it is dull. Remember that sharp tools are
safer than ones that have become dull.
6. Once finished, disconnect the tool from its air source and
discharge any residual air in the tool before storing it.
7. After each use, remove the chisel and the retainer spring and
clean them, making sure there is no accumulated dust or
debris remaining on the tool.
MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace
damaged or worn components.
3. Follow instructions for lubricating and changing accessories.
4. Keep the tool handles clean, dry and free from oil/grease at
all times.
5. Inspect the tool fittings, alignment and hoses and power
supply cord periodically. Have damaged or worn components
repaired or replaced by an authorized technician.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
5 pc Short Barrel Air Hammer Kit V 3.05
9