Dateq ACE Mode D'emploi page 20

Dateq Ace Manual
8
Combined microphone/ line channel (1...4)
These channels can be used to connect a microphone or a line source. The channel is equipped
with gain-control and input-selector. Each microphone channel has a separate phantom-power
supply, a TalkOver circuit and an internal dual equaliser. The microphone inputs have a gain-
trimmer at the connectorboard. Each line-channel has the possibility to adjust the input sensitivity
by means of an internal resistor.
-12
-6
-20
Line
+6
Mic
GAIN Volume preset for both the microphone and the stereo-line input.
MIC/ LINE Input selector.
SIGNAL This LED will light up when a signal is applied to the channel.
The threshold is -30dB for the line input.
Stereo Line inputs (5 and 6)
These channels can be used to connect stereo-line sources. Each channel has a input-selector
and volume-control. Each line-channel has the possibility to adjust the input sensitivity by means of
an internal resistor.
GAIN GAIN
-12
6 -6
-20
0
Line 1
+3
+6
Signal
4
Line 2
GAIN Volume preset for both line inputs.
LINE 1/ LINE 2 Input selector.
SIGNAL This LED will light up when a signal is applied to the channel.
The threshold is -30dB.
GAIN
-12
-6
-20
0
Line
+3
+6
Signal
1
Mic
GAIN
-12
-6
-20
0 0
Line 1
+3 +3
+6
Signal Signal
5 6
Line 2
GAIN
-20
0
Line
+3
Signal
2
Mic
-15
L
R
0
-1 1+
2 2
3 3
4 4
5 5
LOW
Installation
EN