Ego Power+ ST1500F-FC Guide D'utilisation page 24

1. Remove the battery pack.
2. Hold the trimmer head as shown in
Fig. 16 and use one thumb to press
one release tab on either side while
gently pulling on the lower cover
assembly with the other hand to
release the tab.
3. Repeat on the other side to release
the other release tab from the
trimmer head.
4. Remove the lower cover assembly
with the spring from the trimmer
head (Fig. 17 & 18).
5. Remove the cutting line from the
spool (Fig. 18).
6. With one hand holding the upper
cover, use the other hand to grasp
the lower cover assembly and align
the release tabs on the upper cover
with the holes in the lower cover
assembly; use your palm to press
and slightly rotate the lower cover
assembly left and right until the tabs
securely lock with it on both sides
(Fig. 19 & 20).
7. Following the instructions in "LINE
REPLACEMENT" to reload the
cutting line.
24
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER
17
Lower Cover Assembly
18
19
20
Alignment