Télécharger Imprimer la page

Ego Power+ ST1500F-FC Guide D'utilisation page 23

Taille-bordure sans fil de 38 cm à bloc-pile au lithium-ion de 56 volts, tige droite / tige à charnière

Publicité

Les langues disponibles

Les langues disponibles

2. Cut one piece of cutting line 16 ft.
(5m) long. Insert the line into the
eyelet. Push the line until the end
of the line comes out of the other
side of the trimmer head. Pull the
line from the other side until equal
amounts of line appear on both
sides (Fig. 14).
3. Press, while rotating the lower cover
assembly in the direction indicated
by the arrow, to wind the cutting
line into the spool that is inside until
approximately 5.5in. (14cm) of line
is showing on each side (Fig. 15).
4. Push the lower cover assembly
down while pulling on the lines to
manually advance the line and to
check for proper assembly of the
trimmer head.
RELOAD THE CUTTING LINE, IF
NECESSARY
NOTICE: When the cutting line breaks
from the line outlet or the cutting line
is not released when the trimmer head
is tapped, you will need to remove the
remaining cutting line from the spool
inside and follow the steps below to
reload the line.
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER
14
Eyelet
15
16
Release tab
Arrow Direction
5.5" (14 cm)
23

Publicité

loading

Ce manuel est également adapté pour:

St1500fSt1500sfSt1500sf-fc