Something not Working
Problems may be due to causes which can easily be solved before calling the
Technical Service. Please follow these instructions:
SYMPTOM
Door does not close
It is too warm inside
the refrigerator
It is too cold inside the
refrigerator.
The compressor works
continuously.
Noises
Malfunctions
If the electronics in the appliance have detected a fault that prevents the ACTUAL
temperature being measured,the temperature display shows a square. The appliance
will continue to function using a backup programme until your local Customer
Service engineer has repaired the appliance.
Weight surpasses the storage limit of the door shelf so spread
weight more evenly or take some products out.
The appliance is not properly installed. Please look in the
Building-in. section.
Set a lower temperature.
Distribute the food products to allow cold air to circulate around
them.
Make sure that the door is completely closed and that the insulating
strip is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
Set a warmer temperature.
Set a warmer temperature.
The temperature where the cabinet is placed is above normal
room temperature.
Check that the ventilation is sufficient and that the ventilation
openings are unobstructed.
The cause could be the introduction of large quantities of food
and/or frequent opening/closing of the door.
Sometimes this is normal. Temperature control may cause clicking
sounds when the system is connected ordisconnected.
The injected cooling gas may produce a gurgling soundwhile
passing through the tubes.
The motor may cause a humming noise and/or slightbumping.
The insulation material used has a tendency to slighly
increase noise levels, how ever it allows for much better
insulation and a lower energy consumption.
SOLUTION
33