Publicité
Les langues disponibles
Les langues disponibles
3. Side Shelf Assembly
(a). Loosen but do not remove two screws (A2) which are
pre-assembled on the left side panel, then remove the
three ¼" truss head screws (A1) attached on the inside of
the left side shelf and the (A3) screw, hang the side shelf
on the two loosened screws.
(b). Using three ¼" truss head screws (A1) attach side
shelf to firebox from inside the firebox. Insert (A3) one 5/32"
truss head screw, one M4 flat washer to attach the side
shelf control panel to the main control panel. Fully tighten
all loosened screws to secure shelf to firebox. See Fig 6.
4. Igniter and Battery Assembly
a) Remove igniter cover and lock washer from
igniter. Insert igniter through from back of
side burner control panel, secure lock washer
from front of side burner control panel.
b) Install battery (J) into ignition box with
positive terminal facing panel.
c) Replace the ignition battery cap after the
battery has been install. See Fig.7
All manuals and user guides at all-guides.com
A2
Fig.7
Fig.6
A1
A3
J
10
Publicité
