Publicité
Les langues disponibles
Les langues disponibles
2. Remove the nuts of the water intake hoses
to access the filters on the water intake
valves. Clean them with an appropriate
brush. If the filters are too dirty, take them
out by means of pliers and clean them.
3. Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under running water.
4. Replace the gaskets and filters carefully in their
places and tighten the hose nuts by hand.
4.4.5 Draining remaining water
and cleaning the pump filter
The filter system in your machine prevents
solid items such as buttons, coins and fabric
fibers clogging the pump impeller during
discharge of washing water. Thus, the water
will be discharged without any problem and the
service life of the pump will extend.
If the machine fails to drain water, the pump
filter is clogged. Filter must be cleaned
whenever it is clogged or in every 3 months.
Water must be drained off first to clean the
pump filter.
In addition, prior to transporting the machine
(e.g., when moving to another house) and in
case of freezing of the water, water may have
to be drained completely.
A
WARNING
• Foreign substances left in the pump
filter may damage your machine
or may cause noise problem.
In order to clean the dirty filter and discharge
the water:
1. Unplug the machine to cut off the supply
power.
A
WARNING
• Temperature of the water inside the
machine may rise up to 90 ºC. To avoid
burning risk, filter must be cleaned after
the water in the machine cools down.
23 / EN
All manuals and user guides at all-guides.com
2. Some of our products have emergency
draining hose and some does not have.
Follow the steps below to discharge the
water.
Discharging the water when the product does
not have an emergency draining hose:
a. Place a large container in front of the filter to
catch water from the filter.
b. Loosen pump filter (anticlockwise) until
water starts to flow. Fill the flowing water
into the container you have placed in front
of the filter. Always keep a piece of cloth
handy to absorb any spilled water.
c. When the water inside the machine is
finished, take out the filter completely by
turning it.
3. Clean any residues inside the filter as well
as fibers, if any, around the pump impeller
region.
4. Install the filter.
5. If the filter cap is composed of two pieces,
close the filter cap by pressing on the tab.
If it is one piece, seat the tabs in the lower
part into their places first, and then press
the upper part to close.
Washing Machine / User Manual
Publicité
