Dri-Eaz DrizAir 1200 Manuel Du Propriétaire page 9

Owner's Manual
down from a maximum of 60 seconds to 0. The compressor delay gives the machine
time to warm up (when needed). If you don't see a compressor delay countdown, the
machine is ready to go. Once the unit completes the CMPRSR DELAY, the display
reads DEHUMIDIFIER ON, and continues to cycle between TOTAL HOURS, JOB HOURS
and DEHUMIDIFIER ON.
Press the ON-OFF key again to turn the unit off. The display will read DEHUMIDIFIER
OFF.
DISPLAY. Press the DISPLAY key to stop the display at DEHUMIDIFER ON or OFF,
TOTAL HOURS, or JOB HOURS as it cycles. Press DISPLAY again to re-start the display
cycle.
HOW TO CHANGE THE LANGUAGE DISPLAY
CAUTION: While in the change-language mode, pressing other keys can change the
programming of the machine. Do NOT press other keys you're not instructed to press.
Use the DISPLAY key to change the display language.
Follow these steps:
1. Unplug the unit.
2. While holding down the DISPLAY key, plug the unit in. The display reads
ENGLISH.
3. To change to FRANCAIS, DEUTSCH, or ESPANOL, press the DISPLAY key or the
CLEAR key.
4. When the desired language is shown in the display, unplug the unit, and the
language is set.
CLEAR. Press the CLEAR key to reset the JOB HOURS
1. As the display cycles between DEHUMIDIFIER ON, JOB HOURS, and TOTAL
HOURS, press the DISPLAY key when JOB HOURS appears on the screen. That
will make the display read JOB HOURS steadily.
2. Then press the CLEAR key to re-set the numerals to 00000.
3. Press DISPLAY again to re-start the display cycle.
NOTE: the TOTAL HOURS reading cannot be re-set.
PURGE. Press the PURGE key to empty water from the pump reservoir.
During normal operation, the pump purges automatically every six minutes, or
whenever the reservoir is full. The display will read PUMP PURGING with a numeral
countdown. To purge the pump manually:
DrizAir 1200 Owner's Manual108998K
9
© 2023 Legend Brands, Inc.