Dri-Eaz Revolution LGR Guide De Démarrage Rapide

LEGEND BRANDS, INC. | 15180 Josh Wilson Road, Burlington, WA 98233 | Phone: 800-932-3030 LegendBrands.com
WARNING
ADVERTENCI
WARNING! Do not alter or modify your unit in any
way. Use only replacement parts authorized by
Legend Brands. Modifications or use of unapproved
parts could create a hazard and will void your
warranty. Contact your local distributor for assistance.
WARNING! Explosion or combustion hazard due to
flammable refrigerant.
• Do not use in environments with combustible gases,
electric heaters or open flames.
• Do not drill into or braze the dehumidifier.
• Do not attempt to service the refrigeration system!
Only authorized service personnel should service
the refrigeration system.
• Be aware that refrigerant gases can be odorless.
WARNING! Electric shock hazard, rotating fan, hot
surface hazards. Unplug unit before opening cover
for cleaning or servicing. Unit must be grounded.
• Inspect the power cord before use. If cord is
damaged, do not use. Always grasp the plug (not
the cord) to unplug.
• Insert three-prong plug on power cord into a
matching electrically grounded outlet. Do not use
adapter. Never cut off third prong. Do not use an
extension cord.
• The unit must be operated on a 120V/60Hz circuit
protected by a Ground Fault Circuit Interrupter
(GFCI) device.
• Keep motor and wiring dry.
• Do not attempt to repair the unit. For Authorized
Service Centers, contact Legend Brands.
NOTICE: Do not use in environments where corrosive
chemicals are present, such as chlorine.
NOTCE: The unit should not be used by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction. Children should not be allowed
to play with the unit.
127067A (#108110 – QSG)
Quick Start Guide
Revolution LGR Dehumidifier
Patents:
Model #111995 |
http://www.LBpatents.com
For proper disposal, this unit should be taken to a
recycler licensed to process refrigeration equipment.
OPERATING YOUR DEHUMIDIFIER
Set unit upright
NOTICE: Always store, transport, and use the unit in a
horizontal position. If the unit is ever placed in a vertical
position, return it to the horizontal position and let it
stand for at least 30 minutes before turning it on.
Set up drain hose
Connect the end with the quick-connect fitting to the
connector near the bottom of the unit. Unwrap the entire
hose and place the unattached end in a sink, drain,
bucket or outdoors – anywhere that water can drain out
safely. If you use a bucket or other container, check it
regularly to prevent overflows.
NOTICE: Uncoil and straighten the entire drain hose. Do
not leave any part of the hose coiled on the unit and do
not place the end of the hose higher than 20 ft. (6 m)
above the bottom of the unit.
Plug in electrical cord
The dehumidifier should be plugged into a GFCI-
protected 115 volt outlet rated for at least 15 amps.
AT THE END OF THE JOB
NOTICE: The unit will complete the defrost cycle even if
the unit is turned off but still plugged in. Do not unplug
the unit during the defrost cycle, and keep it upright on a
horizontal surface until all water has been purged.
1. Do not turn unit off or move it until it has returned to
normal operating mode, then gently rock the machine to
ensure any water remaining falls into the sump area.
2. Press the PURGE key. When the purge cycle is
complete, turn the unit off and unplug it.
3. Remove the drain hose, drain it carefully, coil it and
secure it with the straps provided.
4. Coil power cord and secure with provided straps.
WARNING: This product may expose you to
chemicals, including lead and phthalates, known
to the State of California to cause cancer, birth defects,
or other reproductive harm. For more information, go to
P65Warnings.ca.gov
CONTAINS: FCC ID 2ADHKWINC3400; IC 20266-
ATWINC3400; CAN-ICES-003(B)/MB-003(B)
1 Legend Brands, Inc.