Publicité
Les langues disponibles
Les langues disponibles
AWARNING
¢
2
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT: All four leveling legs must contact the floor to
support and stabilize the full weight of refrigerator. Rollers are for
moving refrigerator and not for permanent support.
After moving the refrigerator to its final location:
1.
Use a %e" socket driver to turn the leveling bolts clockwise to
extend the legs to the floor as shown. The rollers should be off
the floor.
—\
A. Rear leveling bolt
B. Front leveling bolt
2.
Adjust the leveling legs to level and align the refrigerator from
left to right and front to back so that the refrigerator is level
and aligned with the cabinetry. The cabinetry surface must be
plumb for the ideal fit of the refrigerator side trim.
3.
Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm) of the
top soffit.
NOTE: If an anti-tip board has been used, adjust the leveling
legs until the top of the refrigerator is within 44" (6.35 mm) of
the bottom of the anti-tip board as shown. Do not crush the
compressor cover.
>"V¥4" (6 mm)
max.
2"(6om)
|
ae
A. Center board 14" (6.35 mm) max. above refrigerator
B. Two 2" x 4" x 32" 6 cm x 10 cm x 81 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with the
door alignment or top grille fit. To avoid damage to the cabinet
or leveling legs, do not apply more than 50 inch-pounds
(5.65 Nm) of torque to the leveling bolts. The leveling legs can
be extended to a maximum of 11%" (3.18 cm) below the rollers.
4.
For Classic and Overlay models, additional adjustments may
be needed after the custom panels are installed.
IMPORTANT:
KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would not allow
access to the refrigerator for service.
Door Panels
1.
Remove all tape and door bracing from the refrigerator and
freezer doors.
2.
Remove the screws that attach the handles to the door frame.
3.
Slide the decorative door panels into the door frames.
4.
If needed, route the door panels or install a filler panel
between the doors and the decorative panels. See the
"Classic Series Custom Panels" section in "Installation
Requirements."
UUUUUCUUEEEe81000100
1000
ML
A. Panels
23
Publicité
