Publicité
Les langues disponibles
Les langues disponibles
Connect to Refrigerator
Parts Supplied:
mg
%4" to %" (6.35 mm to 6.35 mm) male-to-male coupling
omens |
t
Vy
Ny
Vy
Vy
Ny
Vy
Vy
Ny
Vy
Vy
ly
Vy
NOTE: The flexible, codes approved water supply line can
connect to the supply valve through the floor or through the side
cabinets, as indicated by the gray boxes above.
1.
Unplug the refrigerator or disconnect power.
2.
Connect the 7 ft (2.13 m) flexible codes approved water tube
to the water supply valve.
3.
Flush the main water supply line to remove particles and air in
the water line. Allow enough flow so that water becomes clear.
4.
Tape the 7 ft (2.13 m) flexible codes approved water supply
line to the floor, 7" (17.78 cm) from the left side of the
refrigerator. Tape along the length of the tubing, which will
allow it to pass beneath the refrigerator without interference.
NOTE: Allow a minimum of 26" (66.04 cm) of flexible codes
approved water supply line to be loose at the front of the
refrigerator for connecting to the refrigerator.
5.
Connect the 7 ft (2.13 m) flexible codes approved water
supply line to the refrigerator.
NOTE: If the main water shutoff valve is behind the
refrigerator, a secondary water shutoff valve may be installed
in line with the water supply line at the front of the product.
E. Bulb
F. Nut
G. Refrigerator water tubing
A. Household water line
B. Nut (purchased)
C. Ferrule (purchased)
D. Coupling
6.
Turn on the water supply valve and check all connections for
leaks.
22
ag oe
fw
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1.
Set control switch at top of cabinet to the OFF position.
2.
Plug into a grounded 3 prong outlet.
AWARNING
¢
2
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT: To avoid floor damage, make sure levelers are
raised (not touching floor) and refrigerator is on rollers before
moving.
1.
Place top of cardboard carton or plywood under refrigerator.
Remove dolly.
2.
Do not remove film or cover.
3.
Move the refrigerator straight back and evenly into the
opening. Be sure that the refrigerator side trims are not
interfering with the door opening. Also, be sure that the water
tubing is not kinked and the power supply cord is on top of the
refrigerator.
Publicité
