Pool
This is used to control pool heating production through an intermediate heat exchanger. Pool production can be enabled / disabled
with an external digital input.
Auxiliary equipment integrated in the heating buffer storage tank
This is used to control an auxiliary unit integrated in the heating buffer storage tank. It can be used for normal heat production or
as emergency equipment.
Auxiliary equipment integrated in the DHW storage tank
This is used to control a support system integrated in the DHW storage tank. This can be used as support to reach higher
temperatures during normal production, to carry out legionella protection programs or as emergency equipment.
Auxiliary boiler
This is used to control start-up / stop of an auxiliary boiler and regulate final temperature downstream from the boiler by a 0-10
Vdc modulating 3-way valve. The heat pump can use the boiler to assist in normal heat, DHW or pool production, or as emergency
equipment.
The hydraulic installation must ensure that while the boiler is operation, the temperature through the
heat pump never exceeds 65ºC, since this could cause serious damage to the refrigerant circuit.
NOTE
Simultaneous production
This is used to control systems that product heat and cold simultaneously. In these types of installations, the heat pump moves
energy from the cold production system to the various heat production systems and controls both the hot and cold outlet
temperature. On the other hand, it uses modulating valves to detour part of the cold or heat production to the brine system,
thereby maintaining the energy balance.
T
AI18
M
AO1
DO15
DO12
Figure 1.11. Wiring scheme using a single buffer storage tank (ecoGeo HP1 models).
All manuals and user guides at all-guides.com
T
AI20
DI1
EVU
DI2
AO2
M
DO2
DO1
DO14
Installer manual ecoGEO HP
DI4
AI19
T
DI3
AI12
DO5
T
DO4
DO6
AI17
T
AI11
T
DO18
DO17
DO3
36
T
DI5
T
DI7
T
DI9
T
T
DI11
T
DI6
T
DI8
T
DI10
T
T
DI12
AI13
T
AI14
T
AI15
T
AI16
T
DO7
DO8
DO9
DO10
AO3
AO4
AO5
AO6
SG2
SG3
SG4
SG5
DG1
DO16
FBus2
T
DI13
T
DI14