Publicité
Les langues disponibles
Les langues disponibles
8
TROUBLESHOOTING
8.1 TRACTION CONTROL SYSTEM (TCS) __________________________________________
The Traction Control System (TCS) is designed to protect the electrical components of the traction and battery
systems. An error code is displayed when a fault condition occurs.
In most instances the traction controls on the tractor will cease to operate when an error condition occurs.
In some cases resetting the TCS will allow the tractor to be restarted and operation resumed. If an error code continues
to occur after resetting the TCS, the tractor should be shut down and returned to a service area for inspection.
Error conditions caused by an electrical problem should be inspected and repaired by an experienced mechanic
familiar with the electrical system of this machine.
Code
-01
Attempting to operate tractor after getting up from
seat.
-02
1. Forward pedal pressed while turning power on.
2. Forward/reverse switch faulty or out of
adjustment.
-03
1. Reverse pedal pressed while turning power on.
2. Forward/reverse switch faulty or out of
adjustment.
-04
Parking brake not engaged while turning power on.
- 06
Forward/reverse switch defective.
- 07
Accelerator input misadjusted or defective.
- 08
Accelerator input misadjusted or defective.
- 09
Forward/reverse switch defective.
- 15
Batteries discharged or defective.
- 16
1. Batteries overcharged.
2. Incorrect batteries used.
- 23
1. Motor field current high on start-up in the
reverse direction.
2. Brakes adjusted too tight.
3. Defective traction controller.
-24
1. Motor field current high on start-up in the
forward direction.
2. Brakes adjusted too tight.
3. Defective traction controller.
All manuals and user guides at all-guides.com
Possible Cause
TROUBLESHOOTING
Action
Reset Power Switch.
Remove foot from pedals while starting.
Inspect and adjust switch.
Remove foot from pedals while starting.
Inspect and adjust switch.
Engage parking brake before starting
Return to maintenance area for service.
Return to maintenance area for service.
Return to maintenance area for service.
Return to maintenance area for service.
Return machine to service area. Inspect condition
of batteries (Section 5.8). Replace or recharge.
Return to maintenance area for service. Check that
maximum battery voltage is less than 57.6 VDC
Return to maintenance area for service.
Return to maintenance area for service.
8
GB-29
Publicité
