Publicité
Les langues disponibles
Les langues disponibles
18
Problem and alarm code
The program does not start.
The appliance does not fill
with water.
The display shows
The appliance does not drain
the water.
The display shows
The anti-flood device is on.
The display shows
The appliance stops and
starts more times during op-
eration.
The program lasts too long.
The remaining time in the dis-
play increases and skips
nearly to the end of program
time.
Small leak from the appliance
door.
The appliance door is difficult
to close.
Rattling/knocking sounds
from inside the appliance.
All manuals and user guides at all-guides.com
Possible cause and solution
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the end
of the countdown.
• The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the proce-
dure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clogged.
• Make sure that the interior filter system is not clogged.
.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap and contact an Authorised Service Cen-
tre.
.
• It is normal. It provides optimal cleaning results and energy
savings.
• Select the TimeManager option to shorten the program
time.
• If the delayed start option is set, cancel the delay setting or
wait for the end of the countdown.
• This is not a defect. The appliance is working correctly.
• The appliance is not levelled. Loosen or tighten the adjusta-
ble feet (if applicable).
• The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
• The appliance is not levelled. Loosen or tighten the adjusta-
ble feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The tableware is not properly arranged in the baskets. Refer
to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
Publicité
