EN
24
•
After the cleaning process, place the device on the edge of the work surface.
Make sure the unit is stable, place a receptacle (bowl) under the unit, remove
the water drain cap at the back, and pull the plug from the drain pipe. The
water in the tank under the drawer and the evaporator will now run into the
water tank. Once the water has drained, reinsert the plug and replace the
water drain cap.
Note: Change the water in the water tank every 24 hours to maintain an
adequate level of hygiene. When the device is not in use, drain all the water and
dry the water tank.
ICE button
•
Before you start making ice, please check the drain pipe behind the machine
and make sure the water drain cap is inserted into the drain pipe. Otherwise
the device will not work properly.
•
Press the ICE button. The icon
and the device starts to work. Press the button again to stop making ice.
During the ice making process, you can see through the viewing window how
much ice has been stored in the drawer.
•
If you are using the machine for the first time or have not used it for a long
time, you should clean it before you start making ice.
•
Check the water level regularly when the ice maker is on. When the water
pump runs out of water, the ice maker will automatically shut off and the ADD
WATER indicator will illuminate. Fill water into the water tank.
LIGHT button
Press the LIGHT button. The light inside the device will turn on. If you press this
button again, the light will go off again.
ICE FULL display
The ice maker will automatically shut off when the ice bucket is full and the ICE
FULL indicator will go on. Remove the ice before proceeding with ice making.
lights up, 5 seconds later this icon flashes