Steba LE 100 Mode D'emploi page 11

∙ Never pull at the power cord or chafe it over sharp edges.
∙ Never leave the appliance unattended when in use.
∙ The manufacturer is not liable for damage which is occurring
due to the usage of the appliance in a different way as descri-
bed or a mistake in the handling has been made.
∙ Place the appliance on a flat, stable, water resisting surface.
∙ The appliance must stand this way that it cannot tip over.
∙ Do not cover the ventilation openings and take care that no
curtains etc can be hindered the air circulation.
∙ Attention! In case of overheating, risk of fire! Keep a
safety distance of min 60cm to wet areas (e.g. Shower,
bath tubes, sinks) and min 120cm to water taps!
Operation:
∙ When the unit is unpacked, place the appliance vertical on the floor and leave it for
12h, that the cooling liquid is bubble free
∙ Take care that the water tank is inserted correctly.
∙ Turn the humidity regulator is turned to "Off"
∙ Plug the appliance in with dry hands.
∙ Ensure that the ventilation openings are open.
∙ Turn the humidity regulator to Pos.4 ( ca 60% humidity).
∙ The compressor is only working when the humidity in the air is higher than the
adjusted. When the compressor is working, then the „Operation" lamp at the panel
is on.
∙ When the regulator is adjusted to „Cont., then the compressor is working perma-
nently.
∙ The unit is suitable to work at temperatures from 5°C to 31°C.
∙ The humidity performance is depending on the surrounding humidity and tempe-
rature. A good dehumidification is achieved at temperatures higher than 22°C and
a humidity above 70%.
∙ When the dehumidifier reaches the adjusted value, the compressor will stop wor-
king and starts again when the humidity is again above the programmed value.
∙ Keep doors and windows closed of the room which should be dehumidified.
Adjusted Ca. humidity
7
6
4
2
30%
40%
60%
80%
11