Zycoo SL50 Guide D'installation Rapide page 6

12
To adjust the angle of the speaker, you can rotate it up or down for maximumly 30 degrees,
or left or right for maximumly 90 degrees.
MAX90°
13
Connect the SL50 speaker to the grounding terminal. If the SL50 speaker is installed with
LTE module, please connect the LTE antenna to the antenna terminal.
Note: It is recommended that the installation height does not exceed 5m.
Web Login
1
Connect network cable and power supply (if PoE is not enabled on the network cable).
2
Wait for 30 seconds then press and hold the RST button for 5 seconds and release, it will
announce the IP address
DHCP fails, it will use default IP 192.168.1.101. In the browser address bar input the IP
address you hear to open its web management interface. Default username and password
admin/admin.
System Reset
To reset factory defaults, press and hold the RST button for 10 seconds (5 seconds for
IP address announcements) and release, now you should hear voice prompts
"Resetting factory defaults, rebooting...", it means the speaker will now reset.
To reset factory defaults, please remove the back plate of the SL50 speaker and use the reset
button.
obtained from the DHCP server. If there's no DHCP server or
4