Zycoo SL50 Guide D'installation Rapide page 4

5
Open the installation package, find the black waterproof connector and unscrew it. Use a
screwdriver to loosen the fixing screw on the middle connector.
6
Use the output wire of the power supply to pass through one end of the waterproof
connector and connect it to the middle connector, tighten the screw with a screwdriver, and
mark the red and black wire holes.(
7
Use the power cord on the SL50 speaker to pass through the other end of the waterproof
connector, connect it to the middle connector, and tighten the screw with a screwdriver.
(Note: The brown wire of the speaker has to correspond to the red wire of the power
supply; the blue wire of the speaker has to correspond to the black wire of the power
supply.)
8
Connect the network cable. Open the installation package to find the metal waterproof
plug and unscrew it. Use a screwdriver to loosen the fixing screw on the connector.
9
Use the network cable to pass through the waterproof plug and connect to the middle
connector. The network cable's #1 and #2 wires correspond to holes #1 and #2,
respectively. The network cable's #3 and #6 wires correspond to the #3 and #4 holes.
Tighten the screws with a screwdriver.
10
After the waterproof plug is screwed and tightened, install it to the network cable hole of
the SL50 speaker.
Terms: The PG9 two-core waterproof aviation connector, abbreviation: waterproof connector.
The M12-4 core type A waterproof aviation plug, abbreviation: waterproof plug.
(1)
SIM卡
(2)
Figure 3)
(3)
2