Publicité
Les langues disponibles
Les langues disponibles
Cleaning and Maintenance
Keep appliance area clear and free from combustible materials,
gasoline and other flammable vapors and liquids.
● Do not block holes in bottom or sides of appliance.
● Check burner flames regularly.
● Use appliance only in well-ventilated space. NEVER use in
enclosed space such as carport, garage, porch, covered patio, or
under ANY overhead construction.
● When LP tank is connected to appliance, store outdoors in
well-ventilated space and out of reach of children.
● Store appliance indoors ONLY if LP tank is turned off,
disconnected and removed from appliance then stored outdoors.
● Keep the appliance clear and free from gasoline and other
flammable vapors and debris.
● Do not obstruct the flow of combustion and ventilation air.
● Keeping the ventilation opening(s) of the LP tank enclosed and
free and clear of debris.
● Replace the gas valve hole if necessary Ensure the gas valve
orifices must be correctly positioned inside the burner tube. If the
burner tube does not fit over the valve orifice, lighting the burner
may causee explostion and/or fire.
Wrong
● We would recommend that appliance should be serviced by
qualified technician at least once a year by a competent engineer.
Do not attempt to service this appliance yourself.
14
Wrong
Correct
PROBLEM
POSSIBLE CAUSE
The connection between
the regulator and LP tank
are not in good condition.
The LP tank valve
control valve do no
open.
The burner dose
not light up.
The LP tank is empty.
High wind condition.
MANUALLY LIGHTING THE BURNERS WITH THE MATCH
LIGHTING STICK
1：Put the control knob in the OFF position.
2：After lighting the match, put it on the burner pipe fitting.
3：Turn on the control knob for 5 seconds to the temperature you
need.
4：Put the control knob in the OFF position.
5：lf the burner does not light within 5 seconds, turn the burner
control knob to "OFF".
6：Wait 5 minutes for the gas to clear, and try again.
7：When lit, turn the control knob to the desired heat setting.
CORRECTIVE ACTION
Check and make sure the
regulator coupling nut is
tightened to the LP tank
valve.
The LP tank valve is
opened in
counter-clockwise direction.
Check and make sure the
LP tank is filled with fuel.
If wind blows out flame, gas
supply will be cut off. Move
out of wind and restart.
15
Publicité
