Russell Hobbs Easy Store Pro Mode D'emploi page 4

AUTO SHUT-OFF
• If the iron is motionless, it will switch off after about 30 seconds with the soleplate down or on its
side, or about 8 minutes if it's upright.
• Your iron will beep six times and the auto shut off light will flash and continue to flash until you move
your iron.
• To switch on again, lift it up, tilt it forward, then sit it upright to return to operating temperature.
FILLING
You may use the iron with tap-water, but if you live in a hard water area, you should use distilled water (not
chemically descaled or softened water).
If you buy distilled water, check that it's suitable for use in irons.
1. Unplug the iron.
2. Hold the iron with the front raised.
3. Open the water inlet cover.
4. Pour slowly, to let the air in the reservoir escape, otherwise you'll cause an air lock and the water will
overflow.
5. Don't fill past the max marking or water will escape in use.
6. Wipe up any spillage.
USING
The temperature of your iron is safe to use on all ironable fabrics and garments.
Dry ironing
If you're going to be dry ironing for 20 minutes or more, empty the reservoir first to avoid spontaneous
bursts of steam.
1. Set the steam control to S.
2. The light will slowly pulse on and off as your iron heats up. When your iron is ready to use, the light
will stay on.
Steam ironing
Set the steam control to the setting you want, S = no steam, S = high steam.
1.
2. The light will slowly pulse on and off as your iron heats up. When your iron is ready to use, the light
will stay on.
SPRAY
Water spotting affects some fabrics. Test this out on a hidden part of the fabric.
1. Lift the iron off the fabric.
2. Aim the spray nozzle at the fabric.
Press the ? button. You may have to press it 2 or 3 times to pump water through the system.
3.
SHOT OF STEAM
1. Lift the iron off the fabric.
Press the h button.
2.
• Leave 4 seconds between shots to let the temperature build up.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
• Check that there's adequate ventilation behind the fabric, otherwise moisture may build up, causing
mildew.
• Check that there's nothing behind the fabric that may be damaged by the steam.
• Check that pockets, turn-ups, and cuffs are empty.
4