Publicité
Les langues disponibles
Les langues disponibles
• Ensure that there is a distance of 50 mm between the hob and the wall or sides.
• The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed
with plenty of space on either side. There may be a wall at the rear and tall units or a wall
at one side. On the other side, however, no unit or divider must stand higher than
the hob.
• The piece of furniture or the support in which the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
• Do not install the hob at the top of a non ventilated oven or a dishwasher.
• Ensure under the bottom of the hob casing a space of 20 mm to ensure good air
circulation of the electronic device.
• If a drawer is placed under the hob, avoid putting into this drawer flammable objects (for
example: sprays) or non heat-resistant objects.
• Materials which are often used to make worktops expand on contact with water. To protect
the cut out edge, apply a coat of varnish or special sealant. Particular care must be taken
when applying the adhesive joint supplied with the hob to prevent any leakage into the
supporting furniture. This gasket ensures a good seal when used in conjunction with
smooth work top surfaces.
• The connection cord should not be subjected to any mechanical constraint.
• Do not use inappropriate child safety shields or hob guards. These can cause accidents.
• The installation of the appliance don't need any preassembling action.
• The extraction piping which isn't included has a standard dimension of 222x89mm.
• The plinth grid must be installed in order to guarantee the good working of the ventilation
system. To ensure proper operation of the ventilation system, a minimum opening of
460cm² is required.
Once the table and the extraction duct
are in place inside the cabinet, press the
duct against the rear of the cabinet to
ensure a tight fit.
46
Publicité
