Tripp-Lite PDU3EVN3L2130 Manuel Du Propriétaire page 14

Features
C13
Outlet Status LED: Once the unit is powered on, each outlet individually
ramps up and each Outlet Status LED will illuminate when the associated
outlet is ready to distribute live AC power.
LED Configuration LED Color
Off
Green
Yellow
Standard 1
Red
Red Flashing
Off
Red
Red Flashing
Alternate
Green
Green Flashing
1 This is the default configuration.
Circuit Breaker (Select Models): There are 3 Load Banks, each
protected by a circuit breaker. If the connected equipment load exceeds
the Maximum Load Rating for those banks of the PDU, the circuit breaker
will trip. Disconnect excess load and reset the breaker.
Note: Each breaker comes equipped with a push-to-reset guard to prevent
Push-to-Reset Guard
accidental breaker tripping. To turn off the breaker, insert a flathead screwdriver into
the reset slot.
Mounting Brackets: Use these brackets as an alternate PDU mounting
method.
Mounting Buttons: Located on the back side of the PDU, the pre-
installed buttons are used for toolless mounting.
Note: Four additional mounting buttons are included for alternate rack styles.
PDUMVROTATEBRKT Mounting Accessory: Use these L-shaped
brackets to mount the PDU with its outlets facing the rear of the rack.
Outlets: During normal operation, the outlets
distribute AC power to connected equipment.
C19
Outlet Status
Off Outlet power is absent
On Circuit breaker is on – Outlet power is present
Outlet's current has exceeded 80% of the outlet current
On
rating – Outlet power is present
Outlet's voltage is below the Low Voltage threshold – Outlet
Off
power is absent
Off Circuit breaker has tripped – Outlet power is absent
Off Outlet power is absent
On Circuit breaker is on – Outlet power is present
Outlet's current has exceeded 80% of the outlet current
On
rating – Outlet power is present
Off Outlet is disabled – Outlet power is absent
Off Circuit breaker has tripped – Outlet power is absent
14
Description