Publicité
Les langues disponibles
Les langues disponibles
ROTATING THE TABLE FOR MITER CUTTING
1.
This miter saw will cut any angle from 0° to 47° right and left. Turn the locking knob (A) Fig. 15 counter-clockwise, lift the miter
detente trigger (B), and rotate the table.
2.
The compound miter saw is equipped with positive stops at 0°, 15°, 22.5°, 31.62°, and 45° left and right.
3.
The pointer (C) Fig. 16 indicates the actual angle of cut. Each scale line (B) represents 1°. When the center line (C) is moved from
one line to the next on the scale, the angle of the cut is changed by 1°.
B
ADJUSTING THE SLIDING FIT BETWEEN THE MOVABLE TABLE AND THE BASE
Disconnect the machine from the power source!
To adjust the sliding fit between the movable table and the base,
turn the nut (A) Fig. 17 clockwise to increase the sliding fit (opposite
to decrease the fit). This adjustment should not be so tight that it
restricts the rotating movement of the table, or so loose that it affects
the accuracy of the saw.
ADJUSTING THE FENCE 90° TO THE BLADE
IMPORTANT: Before making this adjustment, set the blade at 0° to the table. See section "ADJUSTING THE 0° AND 45° BEVEL
POSITIVE STOPS."
Disconnect the machine from the power source!
1.
Rotate the movable table so that the positive stop is set for 0°.
2.
Place one end of a square (A) Fig. 18 against the front of the fence (B) (located under the motor), and the other end against the
blade, with the blade locked in the down position. The fence should be 90° to the blade.
3.
To adjust the fence (B) Fig. 18, use the supplied wrench to loosen the two screws (C) that attach the fence to the base. Adjust
the fence (B), and tighten the screws (C).
4.
Check the opposite fence (D) Fig. 19. To adjust, remove the extension fence, loosen the two screws (E), adjust the fence (D), and
tighten the screws (G).
A
B
All manuals and user guides at all-guides.com
A
Fig. 15
C
Fig. 18
C
A
D
11
B
Fig. 16
Fig. 17
G
Fig. 19
Publicité
