Publicité
Les langues disponibles
Les langues disponibles
ATTACHING THE DUST BAG
Depress the spring clips (A) Fig. 11 of the dust bag (B) and clip
the dust bag (B) over the ribs of the dust chute.
OPERATING CONTROLS AND ADJUSTMENTS
FASTENING THE MACHINE TO A SUPPORTING SURFACE
Before operating your miter saw, firmly mount it to a workbench
or other supporting surface. Four holes (A) Fig. 12 are provided for
fastening the saw to a supporting surface.
When frequently moving the saw from place to place, mount the saw
on a 3/4" piece of plywood. The saw can then be easily moved from
place to place and the plywood can be clamped to the supporting
surface using "C" clamps.
STARTING AND STOPPING THE MACHINE
To start the machine, depress the switch trigger (A) Fig. 13. To stop the machine, release the switch trigger.
This saw is equipped with an automatic electric blade brake. As soon as the switch trigger (A) Fig. 13 is released, the electric brake
is activated and stops the blade in seconds.
A rotating saw blade can be dangerous. After completing the cut, release the switch trigger (A) Fig. 13 to
activate the blade brake. Keep the cuttinghead down until the blade has come to a complete stop.
The torque developed during braking may loosen the arbor screw. The arbor screw should be checked
periodically and tightened if necessary.
LOCKING THE SWITCH IN THE "OFF" POSITION
IMPORTANT: When the miter saw is not in use, the switch should be locked in the "OFF" position, using a padlock (B) Fig. 14 with
a 3/16" diameter shackle to prevent unauthorized use of the saw.
In the event of a power outage, always lock switch in "OFF" position until the main power is restored.
All manuals and user guides at all-guides.com
OPERATION
A
Fig. 13
10
A
B
A
A
Fig. 12
Fig. 11
B
Fig. 14
Publicité
