Publicité
Les langues disponibles
Les langues disponibles
Alternative settings
All manuals and user guides at all-guides.com
Jumper 1 closed
Insertion of two coins available
Jumper 2 closed
Upper Dip for setting of seconds
Lower Dip for setting of minutes
Value of Dip-switch:
1 – 2 – 4 – 8 – 16 – 32
Notice
To secure the activation of basic-settings and
time-settings, it is recommended to cut the
device from power shortly. On first usage, the
LED will flash four digits followed by a break.
The combination of digits indicates the installed
software. The permanent display of the digit „0"
indicates the ready-status.
2.2 time setting
To set the running time, the imprinted values of Dip-switches set to „on" position has to
be added.
E.G.
Upper-Dip-switch
switch 1, 3 and 4 set to „on"
The result of addition of imprinted values is 13
In addiction of basic setting, the running time is set to 13 minutes or 13 seconds.
Lower-Dip-switch
switch 2 and 5 set to „on"
The result of addition of imprinted values is 18
In addition with the values of the upper-Dip-switch the total running time is 18 minutes
and 13 seconds or 18 hours and 13 minutes.
2.3 Display
After insertion of first coin a „1" is displayed. After insertion of a second coin (if activated)
a „2" is displayed. The display will jump back to „1" if the time stock of second coin is used
up. When time stock reaches the last 9 minutes the remaining time flashes on display in
one minute steps. If the running time per coin is set to a lower value than 9 minutes, this
time will flash on display.
NZR – Ihr Partner für Energiemessung
10
Circuit board ZMZ 0205
Münzprüfer
Münzenzählwerk
B
B
1
2
1 2 4 8 16 32
Dip-oben
Dip-unten
Publicité
