Publicité
Les langues disponibles
Les langues disponibles
Installation
4-2
Configure Shutdown Settings: During a loss of utility power, the
SNMPWEBCARD will instruct the UPS to shut down after it has powered connected
loads from battery for 6 minutes. If you want to change the default setting, follow
these instructions:
1. From the initial PowerAlert Status page, click the Settings button
the screen, then click the Events button
2. From the Event Settings page, confirm that On Battery
highlighted, then click the Settings... button
3. In the pop-up dialog window
Save Changes button
4-3
Attach Faceplate: Using one hand to hold the card in place, temporarily detach the
network cable. Align and attach the faceplate that matches your UPS system, using
screws from the accessory slot cover. Reattach the network cable.
Note for Network Management System Users Only: Two MIB files - Tripplite.mib and
RFC1628.mib - must be loaded on each Network Management Station that will
monitor the UPS system via SNMP. The files are provided on the CD-ROM included
in the product package.
All manuals and user guides at all-guides.com
, enter your preferred settings and then click the
F
.
G
B
that appears at the left side of the screen.
B
toward the bottom of the screen.
E
A
7
at the top of
A
and Shutdown
C
D
C
D
E
F
G
are
Publicité
