Publicité
Les langues disponibles
Les langues disponibles
Installation
A
Default Setting
1-5
Determine Installation Method: If your network's DHCP server will assign a
dynamic IP address to the SNMPWEBCARD automatically, proceed to
2 - Dynamic IP Address Assignment. If you will assign a static IP address to the
SNMPWEBCARD manually, proceed to 3 - Static IP Address Assignment. If you are
uncertain which method to use, contact your network administrator for assistance
before continuing the installation process.
2 - Dynamic IP Address Assignment
2-1
Insert SNMPWEBCARD in Accessory Slot: Use a screwdriver to remove the
accessory slot cover from the UPS. While the UPS is turned on, align the
SNMPWEBCARD with the guides in the accessory slot and push the card into the
slot until the ports are nearly even with the rear surface of the UPS.
2-2
Connect SNMPWEBCARD to Network: Connect a standard Ethernet patch cable
to the RJ-45 Ethernet port on the card. Note: This port is not compatible with PoE
(Power over Ethernet) applications. The card will attempt to obtain an IP address via
DHCP. This may take as long as several minutes, depending on your network
environment.
2-3
Discover IP Address: Contact your network administrator to determine which IP
address has been assigned to the card by the DHCP server. The card can be identified
on the DHCP server by referring to its MAC address (see Step
to request a long-term lease period for the IP address, depending on your application.
After you have discovered the IP address, proceed to 4 -Test and Configure.
All manuals and user guides at all-guides.com
B
Alternate Setting
JP2
C
Jumper Location
3
1-3
). You may wish
Publicité
