Sangean WR-2CL Mode D'emploi page 17

FM Stereo/Mono button
1. If a station being received is weak , some hiss may be audible.
To reduce the hiss, press and hold down Mono button until radio
beeps and display shows MONO.
2. Press and hold down the Mono button to return to Stereo
operation.
3. FM stereo is only available when using headphones.
Changing tuning step
Note: remote control unit is not applicable for this operation.
In Europe and other parts of the world, MW tuning steps are 9 kHz,
in America, the MW tuning step is 10 kHz.
On FM, most countries use 100 kHz tuning step, your radio can
however be set so as to allow an FM tuning step of 50 kHz.
1) Adjust FM tuning step
1. Ensure that your radio is switched off. Press and hold down the
M5 button until FM step begins to appear in the display.
Hold down the M5 button for another 8 seconds until FM step
begins to flash in the display .
2. Rotary the Tuning control to adjust required FM tuning step
(Rotary down to get 50 kHz and rotary up to get 100 kHz).
3. Press the M5 button again to complete setting. Display will return
to clock status after setting.
Note: remote control unit is not applicable for this operation.
GB
16