Sangean WR-2CL Mode D'emploi page 15

Scan tuning via remote control device
1. Switch on your radio by pressing the power button.
2. Select the required waveband.
3. Press and hold down either the tuning up or down button
until the frequency in the display begins to change rapidly.
Release the button.
4. Your radio will scan the selected the waveband, stopping each
time it finds a station of sufficient strength. Adjust the volume
control to the required level .
Rotary manual tuning
1. Press the on/off button to switch on your radio.
2. Select the required waveband by repeatedly pressing the
Band button.
3. Rotary tuning the Tuning knob will change the frequency in the
following increments,
FM 50 kHz or 100 kHz
MW 9 kHz or 10 kHz
4. Set the volume and tone controls to the desired settings.
5. To switch off your radio , press the On/Off button.
GB
14