Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi C 7D Instructions De Sécurité Et Mode D'emploi

ASSEMBLY AND OPERATION

APPLICATIONS

Cutting Various types of wood.

REMOVAL AND INSTALLATION METHOD OF BATTERY

Insert
Pull out
Latch
Push
Battery
Fig. 10

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn out.
WARNING:
Do not use the electrical cord if damaged. Have it repaired
immediately.
How to install the battery.
Align both guide rails of the battery and the
tool.
Always insert the battery all the way until it
locks in place with a little click, If not, it may
accidentally fall out of the tool, causing
injury to you or someone around you. (Fig.
4)
How to remove the battery.
Withdraw the battery from the tool while
pressing the latches on both sides of the
battery. (Fig. 4)
English
17