EKVIP 024703 Traduction Des Instructions D'origine page 12

EN
7. Screw the back on the wall.
FIG. 6
8. Connect the wires to the terminal block.
– L = Brown
– N = Blue
– Earth = Green/yellow
FIG. 7
9. Fasten the light on the back.
FIG. 8
10. Unscrew the casings and put in two
light sources with the maximum output
specified for the product. Replace the
casings.
FIG. 9
11. Switch on the power supply.
FIG. 10
IMPORTANT:
• Make sure the mains supply is
disconnected before installation.
• Check that there are no concealed
electrical cables, gas and/or water pipes
where the holes are to be drilled.
MAINTENANCE
1. Switch off the power supply to the light.
2. Wipe the light with a dry or slightly damp
cloth.
3. Wait until the light is completely dry
before switching the power supply on
again.
NOTE:
• Switch off the power supply before
cleaning.
• Do not use detergent, alcohol, solvent or
the equivalent to clean.
12