EKVIP 024703 Traduction Des Instructions D'origine page 11

SAFETY INSTRUCTIONS
• The product is only intended for outdoor
use.
• Switch off the power supply before
installation.
• Before cleaning, maintenance and/or
other work on the product, switch off the
power supply by removing the fuse or
pulling out the plug.
• Products with transformers must only be
used with the original transformer.
• Do not allow children to play with the
packaging material or the product.
• Do not connect the light to the mains
while it is still in the pack.
• Stop using the product immediately if it
gets damaged, especially the power cord,
plug and/or socket, and if it is not working
properly.
• Repairs must be carried out by an
authorised electrician.
• Do not attempt to modify or repair the
product. Repairs that are not carried out
correctly can result in a risk of serious
personal injury and/or death.
• The product's earth wire (green/yellow) is
connected to earth.
• Be careful not to damage the insulation
on the wires during installation. Make sure
that the wires do not come into contact
with sharp edges. Damaged insulation can
result in a risk of electric shock.
• Check that the mains voltage matches the
rated voltage on the type plate.
• The plug, power cord, wires and
connections must not be subjected to
mechanical stress.
• The light must only be used with its casing.
• When the product is switched on the bulb
gets very hot. Allow the product to cool
before replacing the bulb.
ELECTRICAL SAFETY!
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.
SYMBOLS
Read the instructions.
Approved in accordance with the
relevant directives.
Recycle discarded product in
accordance with local regulations.
TECHNICAL DATA
Voltage
Max permitted output of light source 2 x 35 W
Socket
Protection rating
Size
INSTALLATION
1. Tools required for correct installation.
FIG. 1
2. Switch off the power supply.
FIG. 2
3. Undo the screws holding the back of the
light.
FIG. 3
4. Mark out where to drill the mounting
holes.
FIG. 4
5. Drill the holes and insert expander plugs
if necessary.
FIG. 5
6. Make a small hole in the entry for the
power cord. Insert the power cord through
the entry.
230 V ~ 50 Hz
GU10
IP44
L 7.5 x W 10.5 x H 21 cm
EN
11